4.1 issues

[Bryandraves]

Hey guys,

Latest version of beaver installed and I'm having problems. When I load up in beaver cold and dark I have sound for maybe 5 seconds then most of the sounds disappear leaving only flap sound and fuel pump. I go to try and start it and nothing happens. Been having this problem a while and my DHC-2 is unflyable because of it. Please help.

[Taguilo]

Hi,

Please could you check if, while you have sound engine gauges (MP,Temp,etc) work and after sound quits those gauges stop working as well?

Thanks

[Bryandraves]

As I stated I cannot start the engine. So there's no way to check. If I set ready to fly instead of cold and dark the engine runs with sound. I've tried uninstall and reinstall no joy

[Taguilo]

As I stated I cannot start the engine. So there's no way to check. If I set ready to fly instead of cold and dark the engine runs with sound. I've tried uninstall and reinstall no joy

Did you try Autostart? (CTRL-E) if not, please do it and tell us if engine starts and gauges show good data even without sound.

Tomas

[Bryandraves]

Will try when I get home

[Bryandraves]

Ok Autostart does turn the plane on and have engine sounds but no oil/fuel pressure and oil temp reading. Shut the engine off and I have no sound of fuel manual pump etc etc so same problem

[Taguilo]

have you installed any other aircraft after the Beaver?
Did it start to happen after you installed v4.1? Worked ok on v4.0?

Thanks
Tomas

[Bryandraves]

I had the 310 installed. No problems with it. I didnt have these issues in 4.0

[Taguilo]

Ok, tomorrow I'm installing v4.1 and will check. If the Beaver was working fine in v4.0 might indeed be a version issue.

Tomas

[Taguilo]

Hi,
Please check this thread:

viewtopic.php?f=137&t=8437

Tomas

[Bryandraves]

This is going on in a clean install of p3d so the thread is irrelevant

[Taguilo]

Ok so can you check if XMLTools3D entry is present in DLL.XML file?

This thread might be useful :

viewtopic.php?f=137&t=7628#p65828

Tomas

[Bryandraves]

It is not present. Added it will report back

[Bryandraves]

Same problem persists......

[Bryandraves]

So any ideas???