Latest installer B737-200C v4.180823

[doodlebug]

MilViz_B737-200C v4.180823

Latest installer B737-200C v4.180823

CHANGE LOG
08/23-2018
============
1. Fixed the fuel starvation issue causing engines to spool down on RTF load

[JonathanBleeker]

Also fixed the CTD in FSX SE

[dougandsian]

hi sorry tried it in fsx :SE and prep3D V4 exactly as previously reported ?????? Nothing changed does not work

[JonathanBleeker]

Tried uninstalling and re-installing the 732? And re-installed as admin?

[Wings of Gold]

I purchased my P3Dv4 version of B737-200 today. Installed (as Administrator), with antivirus disabled, using latest installer (v4.180823). aircraft is configured to come up ready to fly. Engines are running and gauges look proper on load - but as soon as I apply take-off power my engines start to spool down and the master caution caution comes on. Problem is NOT fixed(as far as I can ascertain).

Bill

[JonathanBleeker]

Do you have any mixture hardware controls?

[Wings of Gold]

Tell me where to look. I had a quick look through the manual, but didn't see what see the location. Will be unavailable after tomorrow for a while,

[JonathanBleeker]

In your P3D control axis menu.

[Wings of Gold]

Hi JB,

I have nothing assigned for "Mixture Axis" under my P3D "Controls\Axis Assignments".

Bill

[JonathanBleeker]

Your problem sounds a bit different to the bug that was actually fixed. What control setup are you using?

[GrizzlyAir]

Will this install to P3Dv5? Or is the 737 not along for the ride to v5 and should I then wait to see if it comes to MSFS?

[Slayer]

Not at this time. I'm not sure if there will be an update for V5 on this product or not.

[Blaunarwal]

Not at this time. I'm not sure if there will be an update for V5 on this product or not.

It works fine in v5, only the MVAMS tool does not find it there. Shouldn´t be that much work but make existing customers happy.

Dan

[Slayer]

Not at this time. I'm not sure if there will be an update for V5 on this product or not.

It works fine in v5, only the MVAMS tool does not find it there. Shouldn´t be that much work but make existing customers happy.

Dan

Prior to MSFS we had A V4/V5 version in progress and there was a lot more broken in V5 then it would appear on the surface. Most of our development is now on MSFS and I don't think there will be further updates at this point.