Engine shuts off / dies within 60 seconds [Resolved]

[neppihd]

Good Morning, i have a problem and i hope you can help me. I bought the Corsair for my ongoing Warbird World Tour and i have only troubles with it. No matter what i do the engine shuts off on the runway or dies within a minute. Doesn't matter if i go with a full start up with check list, starting from the runway or mid air. I lower the rpm & the throttle after take off but that doesn‘t change anything. Its always the same. I also have the problem that i can’t change some of the levers easily (RPM as an example: Not 100% - 75% but 100% - 22%) to the described settings as i should do. I first thought maybe its the airport i used to start from but didn't change after i switched airports. I removed the "better camera mod" but didn't change a thing. I also reinstalled the plane but yeah, didn't change a thing.

Is there anything i can do? Because i'm really annoyed and the plane starts to p*ss me off.

Edit 1: I tried to fill out the Support Ticket but i can't choose MSFS 2020 and i only get a error message because of that.

Edit 2: The Co-Pilot can't even get the plane to move. Sits just on the runway.

[Slayer]

Please try it with only your corsair in the community folder. We have had various reports of several other addons conflicting with our product as they manipulate global variables and behaviors . How are you trying to move the levers? Do you use an axis, are you dragging the levers, using the scroll wheel or key combo to do so?

[neppihd]

Should i only remove the Mods or also my other third party planes? The later one would kinda suck because i need them for my World Tour.

I try to move the levers with my mouse like i do in my other planes. Works perfectly fine in my other planes (down to 1%).

[Slayer]

No need to remove everything permanently, just for trouble shooting. Try manipulating the levers by holding the mouse over it and using scroll wheel on your mouse.

[neppihd]

I found the problem. Well, at least for starting from the Runway & the Air. The Fuel Switch & the Primer Switch are off by default. When i switch them on and also switch the starter too on i can fly without big problems. Will report if i run into other problems.

Just as a heads up: The Update did break the "Tablet". Doesn't show the map or the loadout. Its just bright and empty.