Error with Milviz MVAMS loading 407

[Jas451]

Hi.
I receive the following error when loading the 407 and 530 helio's in Prepar3D v.4, no other sim installed. Have the latest version of both

[Krazycolin]

Hi. First off, did you run the product with admin rights?

Second, are you running the latest version of P3D?

third, are you running p3d as an admin?

[JonathanBleeker]

In this particular case (since the AMS and not the simulator is at fault), please verify that the MVAMS app is set to run as admin.

[Jas451]

Both Prepar3d v4 and AMS are set to run as admin. Forgot to mention after receiving the above error I can only shut down AMS using task manager. Just realized I've only been receiving this error after last few Windows 10 updates.

[JonathanBleeker]

You might want to check that it hasn't reset your permissions.

[Jas451]

Checked the permissions, no error. The permissions are correct.

[doodlebug]

Can you confirm what version you have installed?
Thank you.

[Jas451]

Sorry it's taken so long to get back with a reply. I take care of my wife who has dementia and the past few days have been an adventure I have version 180709 of the 530 and 180309 of the 407

[Jas451]

Still getting this error. Doubled checked that I have the current version of these helio's. Had no problem with these aircraft when run in FSX only began when upgraded to Prepar3d. I uninstalled and reinstalled each several times. I have money invested into these aircraft and I am unable to fly either. Really need help with this.

[mm007]

Hello,

I have similar problems - when I load MVAMS and click Bell 407, I got the following error message. The program does not crash and I can access the other settings, just not Bell 407. Reinstall of 407 helped - for once.

Could you look at this issue, please? Is there a way I could help?

[JonathanBleeker]

https://www.dropbox.com/s/5yz1iu1srq7qi2g/B407.zip?dl=0

Please try this dll and send me screenshots of the popups.

[mm007]

Hi, the popups are here. There is another thing I noticed.

This happens if:
1) I set up force trim as a joystick button, save and exit program
2) I start the program when the joystick is unplugged.

With the joystick plugged in, the MVAMS works as it should.

Hope that helps.

[JonathanBleeker]

Bingo. Thanks for that. That makes clear what the cause on your side is (the other user is different). I will put in a protection system if no joystick is present (bad assumption on my part).

[mm007]

You're welcome. Good luck!