Force Trim Button not working

[seba0412]

After few months i was installed my Bell 407 (vA1.160115).
I was assigned trim button in menu manager, but in flight button is not working.
I remember that few months ago it was worked.

What can be wrong?
I fly on P3D v3.

[JonathanBleeker]

hydraulic pump on?

[seba0412]

Yes. Hydraulic is ON. Besides, i start with "Ready to fly" state.

The same problem is with MD530.

[JonathanBleeker]

Make sure your P3D controls are set to run on DirectInput not Raw Input.

[seba0412]

???? where i can check that?

[JonathanBleeker]

Go to your P3D controls page, and click on the Other tab at the top next to Axes. You will be able to change from there.

[seba0412]

I was changed for DirectInput. Still no force trim.

[JonathanBleeker]

screenshot of the ACM control settings window?

[seba0412]

Here is screenshot

[JonathanBleeker]

https://www.dropbox.com/s/e567e2k1j9jw4 ... F.dll?dl=0

Please put this in your sim gauges folder. It will pop up a dialog window when you press the button you have assigned.

[seba0412]

I was replaced this file as you told, but still no "force trim".
Dialog windo also didn't pop up.

[JonathanBleeker]

Are you running P3D as admin? If you upgraded recently you may need to redo that setting. Right click on your P3D, select properties->Compatibility->Run this program as administrator.

[seba0412]

No, still no go.

P.S.: Very strange, because F100, and F-4E work like a charm, with all assignments maked in ACM. Only Bell 407 and MD 530 have problems with "force trimmer"

[JonathanBleeker]

Ok lets go a little deeper and see if the gauge is actually reading the file where the joystick assignment is made.

https://www.dropbox.com/s/e567e2k1j9jw4 ... F.dll?dl=0

Put that into your gauges folder. When you load the 407, a popup window should come up showing something like this: joystick:X:button:X. Then go to your sim directory\Milviz\B407\Controls.ini and see if the X value matches the device and button numbers in the Controls.ini.

[seba0412]

Yes. The values in controls.ini, matches exactly with popup window.