No ACM showing up
Posted: Mon Nov 29, 2021 7:56 pm
Hi Guys
When pressing Shift+2 I get a black screen and no ACM at all.
Thanks, David
When pressing Shift+2 I get a black screen and no ACM at all.
Thanks, David
Blackbird Sims / Milviz Forum Archive
Read-only archive for legacy products
https://milviz.com/forum/
No ACM showing up
Page 1 of 1
Re: No ACM showing up
Posted: Tue Nov 30, 2021 10:50 pm
Is this the TacPack or non?
Re: No ACM showing up
Posted: Wed Dec 01, 2021 6:04 am
It is the non TP installer.
Thanks, David
Thanks, David
Re: No ACM showing up
Posted: Wed Dec 01, 2021 9:16 pm
Ok and you ran the installer as an admin with AV off?
The only other thing I can think of is something is messed up in your panel files. Have you installed any liveries for this?
The only other thing I can think of is something is messed up in your panel files. Have you installed any liveries for this?
Re: No ACM showing up
Posted: Wed Dec 01, 2021 9:32 pm
No liveries but just noticed I installed it to P3D V5.2 is it a problem?
Thanks, David
Re: No ACM showing up
Posted: Wed Dec 01, 2021 10:20 pm
It hasn't been tested or updated for Prepar3D V5 yet so there may be issues such as this. Not sure if there is going to be an update for it at this point either.
Re: No ACM showing up
Posted: Thu Dec 02, 2021 8:34 am
Re: No ACM showing up
Posted: Tue Dec 07, 2021 1:06 am
Try Shift+1?
Re: No ACM showing up
Posted: Tue Dec 07, 2021 8:46 am
Nope, thanks
Re: No ACM showing up
Posted: Tue Dec 14, 2021 11:18 pm
Enable Content Error logging in P3D and post the content error log?