No ACM showing up

[DAVID_wI]

Hi Guys

When pressing Shift+2 I get a black screen and no ACM at all.

Thanks, David

[Slayer]

Is this the TacPack or non?

[DAVID_wI]

It is the non TP installer.

Thanks, David

[Slayer]

Ok and you ran the installer as an admin with AV off?

The only other thing I can think of is something is messed up in your panel files. Have you installed any liveries for this?

[DAVID_wI]

Ok and you ran the installer as an admin with AV off?

The only other thing I can think of is something is messed up in your panel files. Have you installed any liveries for this?

No liveries but just noticed I installed it to P3D V5.2 is it a problem?

Thanks, David

[Slayer]

It hasn't been tested or updated for Prepar3D V5 yet so there may be issues such as this. Not sure if there is going to be an update for it at this point either.

[DAVID_wI]

It hasn't been tested or updated for Prepar3D V5 yet so there may be issues such as this. Not sure if there is going to be an update for it at this point either.

Thanks for your kind reply, but is there a way to start the engine without the ACM?

[JonathanBleeker]

Try Shift+1?

[DAVID_wI]

Try Shift+1?

Nope, thanks

[JonathanBleeker]

Enable Content Error logging in P3D and post the content error log?