Interior Lights

[farman]

Hi,
don't know if it's linked to the interior lights issue, but from the outside I don't see the afterburner flame when acticated; just its sound.
regards,
Fulvio

[spronkj]

that's an issue I had as well. there was also no glow in the engine nozzles as well. I shut down the engines and restarted them and the glow and the afterburners reappeared. also the landing lights were on with the switch in the off position. When I turned the landing lights off using ctrl + L and then used the switch it then worked properly.

Just some of my experiences with the T-38.

I so like this airplane. I hope the experts have a solution soon!!

[ReggieC]

If you will go to the other post that I started about the interior lights, they sent me a new .dll for the PANEL file and it fixed the problem for me. You might give that a try.

Reggie

[farman]

Hi all,
sadly, I'm still flying the T-38 (standard version for P3D v3.2) only by daylight. I just tried to re-install it, give all the permissions, disabled all the anti-virus. All to no avail.
it's a real pity.
Regards,
Fulvio

[Krazycolin]

I'm sorry Fulvio... but there's not much we can do if you did absolutely EVERYTHING that was suggested...

[JonathanBleeker]

I'm not going to give up quite yet....I want to double check your lighting exe and dll version numbers please.

[farman]

Hi,
thanks for your further help.
Attached my .dll & .exe Lights version. Is this you asked for?
regards,
Fulvio

[JonathanBleeker]

Ok you are using the updated versions. Please post the error report from the NL.exe crash so I can trace the offset.

[farman]

Hi Jonathan,
attached the only error I found in the event log. Attached even some shot of the interior (with light test switch ON) and exterior.
Well, from the TM I didn't see any MV_NL.exe start, as per the other MilVIz planes (F-4 and so on).
It's a real mistery; I don't think I'm missing anything, due to the lots and lots of planes I flew so far. Maybe there's some issue that generates some kind of incompatibility betwenn my pc and the T-38. Who knows?
Well, much more important for the F-4 updating to P3D v3.2.
Thanks again for your seriousness and professionalism in coping with this weird problem.
regards,
Fulvio

[JonathanBleeker]

Is the MV_NL.exe in your task manager?

[farman]

No, I didn't see it; actually, I even open the TM just remembering this issue in the F-4. But it should be seen, correct?
Just to try a desperate move, what do you think to send me the link to re-download the full T-38 .exe? I apologize in advance if this is an indecent proposal
Fulvio

[farman]

Hi, might I get again the download link that - silly me - I can't actually find in my folders? Who knows, perhaps redownloading and reinstalling it I could recover some missing file or exe. Only a very fa chance, but just to try a last time.
Thanks and regards,
Fulvio

[JonathanBleeker]

KC? Kat? Can you help him out?

[Kat]

I have sent an email containing the download link via sendowl

[farman]

Hi Kat, got it. Thanks for your kindness.
Feedback will follow; this time I'll deactivate my Microsoft Antivirus that, anyway, never gave me any problem. But who knows, maybe something happened downloading the T-38 exe; some corrupted file or who the hell knows!
Regards,
Fulvio