Page 1 of 1
Beaver addon
Posted: Sun Jun 25, 2017 7:51 pm
by skyhawk18
I am about to convert the amphib N9028 to straight floats with Barron STOL kit. As the title of this forum says - this is WIP.
The straight floats and STOL kit are part of a Beaver addon that is currently under development:
viewtopic.php?f=136&t=7778
- 9028 STOL1.jpg (233.36 KiB) Viewed 7466 times
- 9028 STOL2.jpg (199.77 KiB) Viewed 7466 times
- 9028 STOL5.jpg (221.61 KiB) Viewed 7466 times
Re: Beaver addon
Posted: Mon Jun 26, 2017 11:45 pm
by skyhawk18
Re: Beaver addon
Posted: Wed Jun 28, 2017 5:13 pm
by Flyboy1
You need to check those Straight Floats - the side step from the Amphibian version should not be there. No need for a step when the floats are in the water all the time and it looks out of place.
Paint looks great. Does the STOL package make a big difference in performance?
Regards,
Ray
Re: Beaver addon
Posted: Thu Jun 29, 2017 9:33 am
by skyhawk18
Flyboy1 wrote:You need to check those Straight Floats - the side step from the Amphibian version should not be there. No need for a step when the floats are in the water all the time and it looks out of place.
Paint looks great. Does the STOL package make a big difference in performance?
Regards,
Ray
The side steps will be removed on the straight float models.
Re: Beaver addon
Posted: Fri Jul 07, 2017 5:49 pm
by skyhawk18
skyhawk18 wrote:Flyboy1 wrote:You need to check those Straight Floats - the side step from the Amphibian version should not be there. No need for a step when the floats are in the water all the time and it looks out of place.
Paint looks great. Does the STOL package make a big difference in performance?
Regards,
Ray
The side steps will be removed on the straight float models.
Steps are fixed:
- a.jpg (235.83 KiB) Viewed 7190 times
- d.jpg (171.08 KiB) Viewed 7190 times