Start Up and MVAMS2
Posted: Sat Nov 05, 2022 7:14 am
Hello all,
I recently bought the A-1H Skyraider. I installed it, following the instructions: no anti-virus, running as an Administrator, etc.
But I cannot seem to make a proper start up, as per the manual. I turn on the fuel boot pump, and the fuel pressure moves just a bit, but does not get nowhere near the required (per manual) 16 PSI pressure. Turn on the magnetos to both, mixture off, I press primer, and the starter. The engine starts turning but does not catch. I've tried and tried this, and the only way it catches is by using the Crtl+E P3D shortcut. After that, everything is ok.
Also, the MVAMS2 program does not open. I click on it, or use the right click menu to run it as an administrator, but in each case the software does not open. I don't know if I need it to make the A-1 work properly.
I recently bought the A-1H Skyraider. I installed it, following the instructions: no anti-virus, running as an Administrator, etc.
But I cannot seem to make a proper start up, as per the manual. I turn on the fuel boot pump, and the fuel pressure moves just a bit, but does not get nowhere near the required (per manual) 16 PSI pressure. Turn on the magnetos to both, mixture off, I press primer, and the starter. The engine starts turning but does not catch. I've tried and tried this, and the only way it catches is by using the Crtl+E P3D shortcut. After that, everything is ok.
Also, the MVAMS2 program does not open. I click on it, or use the right click menu to run it as an administrator, but in each case the software does not open. I don't know if I need it to make the A-1 work properly.