MD530F-PBR latest installer [updated]

[doodlebug]

https://milviz.com/Online_products/Prod ... 200415.zip

Fresh off the presses - as yet untested

Fixes pontoons & nightlighting

[bvdboomen]

Cool, thanks!
I'll give it a swing today.

[gabichnz9]

https://milviz.com/Online_products/Prod ... 200415.zip

Fresh off the presses - as yet untested

Fixes pontoons & nightlighting

Hi Osh, as per email this evening I have advised that I have purchased this beauty through Orbx Simulation Systems Manager. How would I go about this one? I will get the zip from here but will i just have to un-install the one from there. If it works will you update the one there?


Gabe

[gabichnz9]

Hi, latest installer did not do much for me yet, issues reported recently have not been fixed for me, see screenshots

https://imgur.com/a/u53yE7K

[Slayer]

Hi, latest installer did not do much for me yet, issues reported recently have not been fixed for me, see screenshots

https://imgur.com/a/u53yE7K

The wire cutters cannot be turned off as apparently the helicopter was always equipped with it. The option to remove them was mistakenly left in the MVAMS. As for the big spotlight, you did have the night sun checked in MVAMS...

[gabichnz9]

Oh, at least I know why P.S have another update. I the pontoons are fine now however ONLY from the inside view, rear seat, textures for the rear door are broken. Example helo is the yellow variant

see here: https://imgur.com/a/pTbZt3i

[gabichnz9]

I have also spotted this 3d cube I am not sure why its there or where it comes from but you can see it bellow you if your helicopter is at least 2,000ft above ground

see here: https://imgur.com/a/LzxTLxZ

[Slayer]

Oh, at least I know why P.S have another update. I the pontoons are fine now however ONLY from the inside view, rear seat, textures for the rear door are broken. Example helo is the yellow variant

see here: https://imgur.com/a/pTbZt3i

The texture issue was reported already and will be corrected. Are you using any camera addons?

[dj3185]

How does one use the above zip file if they have purchase this product through Orbx?

Thanks,

David

[Slayer]

In Orbx central there should be a spot to view your product key. Can I ask does Orbx have the outdated version still? We may have to reach out so that they get theirs updated.

[dj3185]

I could not find anywhere in ORBX where it shows my product key.

I did find a version located in a xml file as shown below. Hope that helps.


C:\Program Files\Lockheed Martin\Prepar3D v4\Milviz\MVAMS\Versions\MD530\MD530.xml

<Version>2.1.0.1</Version>