Page 1 of 1
I can't get off the ground
Posted: Fri Dec 20, 2019 1:23 am
by jfwharton
Today I purchased the T38 Advanced Redux. Got everything configured and I can't get the aircraft to leave the ground. Don't know what is going on. Flaps are set to 50, T/O trim is set. From the exterior view when I move my joystick I can see the appropriate flight controls move, yet when I reach 145 knots and start pulling back the nose does not rise and then finally the aircraft hits the burner cans and the aircraft crashes. Any ideas? It's as if the tires are glued to the runway.
Re: I can't get off the ground
Posted: Fri Dec 20, 2019 7:48 am
by JonathanBleeker
You running EZCA/EZDock?
Re: I can't get off the ground
Posted: Mon Dec 23, 2019 4:21 pm
by jfwharton
Yes I was running EZDOK V3 the latest version. What was interesting was if I turned EZDOK off after configuring everything I could takeoff. But if I turned EZDOK back on after that the AOA would go off scale high and the aircraft would stall. This has been reported to EZDOK support and they replied that they were in contact with MILVIZ to get this issue resolved. In the mean time I purchased Chaseplane and everything is working properly with that add on.