Page 1 of 1
P180 Unable to Monitor Com2
Posted: Tue Dec 14, 2021 1:02 pm
by pheonixtaylor
There is no mention on how to monitor a frequency in the User Guide and appears it may not be possible in the P180?
Re: P180 Unable to Monitor Com2
Posted: Wed Dec 15, 2021 9:40 pm
by Slayer
I believe this came up during testing, the solution is to flip the AUTO COM switch to ON instead to monitor COM2. Should be the way it works.
Re: P180 Unable to Monitor Com2
Posted: Wed Dec 15, 2021 11:39 pm
by pheonixtaylor
That's the way in the King Air and the AutoCom switch is in a very obvious location. I'm unable to locate the button in the P180's cockpit or find mention of the button in the User Guide.
Re: P180 Unable to Monitor Com2
Posted: Thu Dec 16, 2021 10:44 pm
by Slayer
Sorry I was looking at notes from the KA. It should be the push buttons on the audio panel but they appear not to be working in Prepar3D 5.3 nor does tuning the frequency in the RTU I can't hear the ATIS from AS either. Com1 appears to work ok but not Com2.