Page 1 of 1
Push STD/ push HDG sync not working[Resolved]
Posted: Sun Jul 25, 2021 1:28 pm
by pm99
Hi,
I’m left clicking on the baro knob/HDG knob, but the altimeter doesn’t change to standard, nor does the heading sync.
I’m assuming these are modelled? Could it be a pilot error
, or an installation problem (ORBX)?
Re: Push STD/ push HDG sync not working
Posted: Sun Jul 25, 2021 9:42 pm
by Slayer
There is a known conflict with chaseplane that will block the clicking with the mousewheel on some peoples systems. The only work around at the moment is to disable chaseplane as even with the MMB disabled it still blocks the click getting to our addon. I've forwarded this to the chaseplane dev quite some time ago.
Re: Push STD/ push HDG sync not working
Posted: Mon Jul 26, 2021 1:53 am
by Taguilo
Hi,
Left click won't work. Push the mouse wheel (center click). All pushable center knobs work the same.
Tomas
Re: Push STD/ push HDG sync not working
Posted: Mon Jul 26, 2021 10:06 am
by pm99
Many thanks, using the middle mouse button worked. (Tested without Chase plane).