axes dont work

[tekrc]

I set up the axes in fsuipc as best I could though I dont know what the "enum" part of the event name is since that doesnt show up so maybe its wrong?

Axis Assignment> Send to FS as normal axis> Axis Throttle 1 Set. thats the closet i can find to what the manual says to use. but using that the throttles just get stuck in one place and make an audible clicking the whole time I move the controls. happens to both throttles and prop bindings

[Raptor]

In addition to FSUIPC, go into MVAMS2 and set your axis there

[tekrc]

In addition to FSUIPC, go into MVAMS2 and set your axis there

the axes dont seem to set there. just selects what im using to set the gates up with. its a calibration screen not a binding screen. evident by switching to the next binding, doing that, going back to find the axis not bound

[Slayer]

Correct this does not do bindings it allows you to calibrate an existing binding or Axis

1) Are you using Honeycomb hardware? If so you may only get it too work by setting the axis up via P3D axis settings.
2) with FSUIPC do not use FSUIPC calibrations or our settings in MVAMS2 will not work

[tekrc]

Correct this does not do bindings it allows you to calibrate an existing binding or Axis

1) Are you using Honeycomb hardware? If so you may only get it too work by setting the axis up via P3D axis settings.
2) with FSUIPC do not use FSUIPC calibrations or our settings in MVAMS2 will not work

thrustmaster warthog.
I am useing "send to FS as normal axis"

[Slayer]

I have the TMWH as well I will check it. Did you hit save after setting it?

[tekrc]

I have the TMWH as well I will check it. Did you hit save after setting it?

after setting the gates? yes.

[Raptor]

Do you have any conflicts with P3D controls?

Also, I have seen in the past were there are conflicts when you have set your controls as DirectInput instead of Raw (I have Raw)

[tekrc]

Do you have any conflicts with P3D controls?

Also, I have seen in the past were there are conflicts when you have set your controls as DirectInput instead of Raw (I have Raw)

Ive been using controls exclusively through uipc for a while now. no axes bound in p3d's options. and new profile for the plane so no conflicts there

[Slayer]

FSUIPC does work but like the KA if you do use it you cannot calibrate the axis in FSUIPC.

[sharpless281]

I am not having axis issues but when I set Propeller 1 and 2 number 1 is moving very slow compare to 2. (KA does not do that)
I have calibration off in FSUIPC (normal)