Keeps trying to Update to V1.1.4 [Resolved - Server side issue]

[Olcesea]

Hello, purchased the product this afternoon (~1PM US East Coast). Downloaded and installed. Ran the MVAMS and it told me there was an update to 1.1.4. Ran update which appeared to run correctly. Ran a soft reboot on the system. Ran the MVAMS a second time and was told to update to V1.1.4. Repeated above. Issue continues.

How do I tell what version I'm on? How do I get out of the V1.1.4 update loop?

[Olcesea]

UPDATE: Now when I try to use the aircraft, I'm told there is an activation problem.

[Floh124!]

Same for me (I mean the MVAMS tries to update every time I open it up). I've manually installed 1.1.4.0_210321.

If I want to use the "MVAMS2 Update Tool.exe" in the MVAMS directory it shows the following message

Avanti.jpg (16.33 KiB) Viewed 346 times

Best regards
Floh

[JPL19]

UPDATE: Now when I try to use the aircraft, I'm told there is an activation problem.

Same issue - you have to just ignore the update message or it wipes out you key info, and still wants to update anyway the next time.

I have uninstalled and reinstalled 4-5 times since late last week. Each time going back and redoing axis set ups, etc.

[doodlebug]

The MVAMS error has been fixed.
Apologies for the inconvenience

[Floh124!]

Hi Oisin,
can confirm this! Now it doesn't want to update anymore.

[Olcesea]

The MVAMS error has been fixed.
Apologies for the inconvenience

So what do we do? Update again and the MVAMS fix will be applied?

[Slayer]

I believe that was a server side problem you shouldn't need to update again.

[Slayer]

If you ran out of activation zones please contact Osh to get reset. info@milviz.com