Page 1 of 1
Autopilot [Resolved]
Posted: Fri Jul 17, 2020 12:42 pm
by romoni
Hello!
I have Radios setting -> Flight1 GTN 750/650.
It's very hard to get Autopilot ON. I must use a Yoke button because using a mouse button not work. Ok - after Autopilot start all other buttons work but NAV-button not response and stay gray color.
Any idea about what is wrong?
Rolf
Re: Autopilot
Posted: Sun Jul 19, 2020 3:26 pm
by Slayer
Not sure what you mean regarding NAV button stays grey in color? I tried testing it , not seeing the problem here.
Re: Autopilot
Posted: Mon Jul 20, 2020 11:14 am
by romoni
Yes - I mean color.
Alt button works, Hdg button works, App button works but Nav button not work. For example A2A Skylane 182 autopilot works as it should be with GTN 750.
Rolf
Re: Autopilot
Posted: Mon Jul 20, 2020 11:43 pm
by Slayer
I see what you mean regarding the autopilot being hard to turn on. Nav doesn't seem to do anything here but heading does as you say.
I'm going to have one of the devs take a look.
Re: Autopilot
Posted: Tue Jul 21, 2020 11:50 am
by romoni
Thank You!
Rolf
Re: Autopilot
Posted: Wed Jul 22, 2020 2:46 pm
by Slayer
Ok I have an answer from a dev for you.
Autopilot button needs to be pressed and held for longer than 2 seconds to become active.
If using a GTN 750 it depends how it is configured. GPS and AUT modes must be active in the panel below the HSI.
Re: Autopilot
Posted: Thu Jul 23, 2020 10:38 am
by romoni
Ok - thank You. I will test these tips. BTW - I really pushed AP button over 2 sec but nothing happened earlier.
Rolf
Re: Autopilot
Posted: Thu Jul 23, 2020 11:09 am
by romoni
This was the trick:
GPS and AUT modes must be active in the panel below the HSI
Thank You for Yours help!
Rolf