CWS dead zone too wide
Posted: Wed Apr 15, 2020 11:22 am
Good morning,
I often use the autopilot in ROL mode with the CWS on to correct the heading.
But I noticed that the dead zone before the aircraft reacts to my yoke, ...is very wide...about 20 deg
It is not a yoke issue...as I get an immediate feedback when I am flying without the autopilot.
Is there a way to reduce this dead zone,,,and to get a more sensitive response?
thank you,
Regards,
Stefano
I often use the autopilot in ROL mode with the CWS on to correct the heading.
But I noticed that the dead zone before the aircraft reacts to my yoke, ...is very wide...about 20 deg
It is not a yoke issue...as I get an immediate feedback when I am flying without the autopilot.
Is there a way to reduce this dead zone,,,and to get a more sensitive response?
thank you,
Regards,
Stefano