RXP GNS

[Chuck Jodry]

Apologies for the late reply , was away for a few days , thank you for the ini , I will try the selections out and determine how to fix it .

Thanks for your patience , getting up to speed today

Best CJ

[ificratis]

Thank you very much for the reply Chuck, I appreciate. I will be glad to hear about how to fix it.

[Chuck Jodry]

Hello , as was mentioned earlier in the thread the issue was a configuration file , I have attached a copy of the two RXP files .

unzip them and drop in the MV-PC6_base/Panel/Console folder to align the placement , this was included in the service pack's build folder, I am not certain why your install had the previous one , did you run one of the reduced resolution packs ?

Best CJ

[ificratis]

Hello Chuck and thank you very much for the reply.

I installed as you indicated, but I still have problems:



The GNS530 has no operative 3d panel buttons and the GNS430 is only displayed as a pop-up, not in the 3D VC model.

No, I had not installed any reduced resolution packs. I had done a clean install of the latest version v1.190718

[Chuck Jodry]

Hello all , the issue if It continues may be a case of applicable versions and the location of the console configuration files.

There are V1 and V2 versions of rxp's units and they run only in the respective sims they were authored for , in order for further diagnosis of the issue a copy of the panel.cfg running and the sim its running in are essential.

Best CJ