Cessna UpDate 4.170727

[SaltyDog]

Hi,

I just update the Cessna 310 with update 4.170727 in P3D V3.4..... I removed the older version first then installed the newer version.

The issue I am having is with the MVAS System. It also has the F4's with it as well - When I opened it up and clicked on the C 310 preferences, I selected the chocks.pax and wing tubes.

Now when I ran P3D V3.4 and selected the 310R, the plane in on the default runway with engines running and the chocks are visable. I wanted to remove the chocks, and this is where things

go a bit awry, I consulted the manual (Page 116) and in the preflight utility:

PREFLIGHT UTILITY
The MilViz C-310R features a utility that allows
the pilot to toggle on/off the pilot (exterior
views only), chocks, and inlet plugs and pitot
tube covers. You can access the Preflight
Utility by either selecting “Shift-7” on your
keyboard, or by right clicking the virtual
cockpit panel to then select the “Cockpit”
option.

I also do not see image below when I press Shift 7 - I get a Shift + 7 is not mapped. H- E- L- P please!!

[Krazycolin]

Manual was not updated. You must open up the mvams and deselect chocks.

[SaltyDog]

Thanks Colin...

Are there plans to put the SHIFT + 7 feature back like it was before and display the screen I posted above?

[Krazycolin]

No. Mvams works at all times.

[ollifreund]

Hi there,

thanks for the update, I appreciate the continued support!! The C310 is my favorite GA plane in MSFS.

I would like to note 2 things:
There is no °C temperature readout on the OAT, as reported before. Just needs
a few blue numbers in the texture.

The fuel-flow gauge does not work on my P3Dv3. While the engines react to FF-change,
the needle does not move until the engine turns off due to fuel starvation.

[vgbaron]

I can second the Fuel flow inop in P3Dv4 also. Fuel control works, just doesn't show on the gauge.

Vic

[Krazycolin]

We're aware and a fix is incoming... Next week likely