Page 1 of 1
F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 9:01 am
by Thorsten42
Hi,
just testing the latest SP installer 180724 and found a minor graphical issue with the F1 GTN 750. If master and nav master switches off all fine. As soon as you put master on with nav master off the "off" black screen of the 750 is gone and you can see the cockpit texture. See screen attached.
Cheers
T.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 4:06 pm
by YoYo
Which simulator?
Which version of GTN 750 of F1?
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 4:26 pm
by Thorsten42
Sorry yes... too warm here and forgot the basics... F1 GTN in P3D v4.3.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 4:28 pm
by YoYo
Thorsten42 wrote: ↑Fri Jul 27, 2018 4:26 pm
Sorry yes... too warm here and forgot the basics... F1 GTN in P3D v4.3.
Can You check the GTN version?
Its on configurator tool.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 4:33 pm
by Thorsten42
GTN CONFIG P3D V2.06 it says.
Cheers T.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 4:48 pm
by YoYo
Thorsten42 wrote: ↑Fri Jul 27, 2018 4:33 pm
GTN CONFIG P3D V2.06 it says.
Cheers T.
Ok, so the current.
Thx for info.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 7:22 pm
by Flyfox
I observed the same little problem with the latest version installed into FSX-SE.
Additional note: Just noticed that a new SP is available since this afternoon, which also addresses this issue.
Re: F1 GTN750 screen blanks with master switch
Posted: Fri Jul 27, 2018 9:25 pm
by YoYo
This issue with placeholder on F1 GTN 750 is solved from DHC3 Turbo: SP1.1 v1.180727 version.