Lots of CTD
Posted: Wed Jul 18, 2018 6:47 pm
Hello,
Flew 10 times with this plane and unfortunately 8 times a CTD. Most of the times it happens during climb shortly after takeoff. The plane crashes even when all the engine gauges (torque <55%, ITT, RPM, Ng) are safely in the green zone, flaps up, speed of the sea plane below 120 IAS and climb speed is around 500 fpm. Tanks were 100% full, but just 2 passengers. Other times the engine suddenly stops working with no logical reason (all gauges green and settings conform checklist). Every time i want to reset the flight (engine can't be restarted) a CTD occurs. Enclosed the last crash report.
Frustrating these crashes, especially when you have to start up again p3d v4.3 after each crash and can't find a reason of the airplane failures.
Hopefuly you can find a cause in the attached crash reports.
Regards,
Edgar
Flew 10 times with this plane and unfortunately 8 times a CTD. Most of the times it happens during climb shortly after takeoff. The plane crashes even when all the engine gauges (torque <55%, ITT, RPM, Ng) are safely in the green zone, flaps up, speed of the sea plane below 120 IAS and climb speed is around 500 fpm. Tanks were 100% full, but just 2 passengers. Other times the engine suddenly stops working with no logical reason (all gauges green and settings conform checklist). Every time i want to reset the flight (engine can't be restarted) a CTD occurs. Enclosed the last crash report.
Frustrating these crashes, especially when you have to start up again p3d v4.3 after each crash and can't find a reason of the airplane failures.
Hopefuly you can find a cause in the attached crash reports.
Regards,
Edgar