Blackbird Sims / Milviz Forum Archive

Hello,

I don't know if it should be like that, but the Plane is pitching to the right all the time after take off and you can't trim that out.

Best Regards

Please try calibrating your controls.

Allready did that and also calibrated FSUIPC.

Trim the rudder, control in cockpit ceiling.

Tomas

Also with rudder trim to full left, the plane is applying a right pitch.

Which version, FSX or P3D?

Thanks!
Tomas

I'm using P3D V4.3.

Just to clarify it a bit more, immediately after take off the plane is rolling to the right and the rolling won't stop. Also tried to change the weight in P3D but with no effort.

I can't reproduce this. By default, there is a pilot in the left seat and the plane rolls ever so slightly to the left and can easily be trimmed out. Then again, I don't use FSUIPC.

Also with FSUIPC set off it's rolling to the right.

Even after full reinstall, calibration of joystick and reset of FSUIPC is the plane still rolling to the right.

If you go into the FS/P3D fuel and payload manager where is the CoG located?

It is located in the middle.

Does this happen with any other airplanes? I think you are the only one with this problem and by the sounds of it, it is controller related. To prove it, can you unplug your controllers and try to fly with the keyboard and see what happens?

Also rolling to the right with keyboard. I am using the Thrustmaster Warthog and Saitek Pro Flight Pedals. And it only occurs with the DHC-3 T.