Page 1 of 1
Flap Extension Issue
Posted: Thu Jan 23, 2020 6:05 pm
by raywhite
When I click on the flap lever it extends fully to the full down position. I have a key programmed to extend them incrementally but even if I use that they still travel through all stops to the down position. Am I missing something?
Re: Flap Extension Issue
Posted: Mon Jan 27, 2020 3:39 pm
by doodlebug
How is it programmed? In P3D options?
Re: Flap Extension Issue
Posted: Mon Jan 27, 2020 11:17 pm
by raywhite
I have a key assigned to the command "extend flaps incrementally". I also have a Saitek MFD and a single press on the flap lever causes the flaps to travel to the full down position. Is there a way to extend them in th VC one notch at a time?