Flap Extension Issue
-
- Posts: 12
- Joined: Mon Jan 07, 2019 9:31 pm
Flap Extension Issue
When I click on the flap lever it extends fully to the full down position. I have a key programmed to extend them incrementally but even if I use that they still travel through all stops to the down position. Am I missing something?
- doodlebug
- Posts: 1642
- Joined: Sun Feb 19, 2017 2:49 pm
- Location: LYX>YUL
Re: Flap Extension Issue
How is it programmed? In P3D options?
-
- Posts: 12
- Joined: Mon Jan 07, 2019 9:31 pm
Re: Flap Extension Issue
I have a key assigned to the command "extend flaps incrementally". I also have a Saitek MFD and a single press on the flap lever causes the flaps to travel to the full down position. Is there a way to extend them in th VC one notch at a time?