Page 1 of 1
Afterburners will not show
Posted: Wed Jan 10, 2018 2:20 am
by retnavycpo
The afterburners will not show lit up unless I press and hold the "L" key. Prior to installing the ADV addon I just purchased, the afterburners did show up. Pete
Re: Afterburners will not show
Posted: Wed Jan 10, 2018 6:58 am
by Alvaro
The afterburners are triggered with throttle positions in the ADV. This must be configured in the AMS. A 80-85% throttle position threshold should be fine.
Re: Afterburners will not show
Posted: Wed Jan 10, 2018 2:09 pm
by retnavycpo
Thanks, I will reach the manual (as I should already have), and try it again! Pete
Re: Afterburners will not show
Posted: Sat Jan 13, 2018 12:06 am
by retnavycpo
Still having same problem. Throttles at suggested percentage does not show afterburner. Pete
Re: Afterburners will not show
Posted: Sat Jan 13, 2018 9:24 am
by Alvaro
Which simulator are you using? FSX, P3Dv3, PD3v4...
If the ADV module is correctly loaded (controls responding), the only way I find to replicate your problem is by setting Throttle axis "Sensitivity" and "Null zone" to quite extreme values. If this happens, the ADV engine model fails to detect the throttles are whithin AB lightoff threshold.
Please, if you are modifying these values, try resetting them to default configuration. The same if you´re intercepting and modifying throttles I/O using FSUIPC.