Blackbird Sims / Milviz Forum Archive

Good afternoon SIM Pilots, ,

Last December I bougth actual Prepar3d V4 lisence from Lookeed Martin as well as Milviz Phantom F-4E and F-4S/J advanced sets.
I installed according to Milvis instructions, but I still have some features which are not work in a proper way.

- I cannot get visible flames in "afterburner modes"
- GUP does not spool to wind the jet enginens to start
- No rear cockpit light and no instrument illumination
- Cannot find the page to select or adjust "failures"

Perhaps I need to perform a Prepar / Miliz synchronizing to get the features working in a proper way?
After watching serval tutorials without getting hinds to solve my issues, I ask you for support again.

Thank you in advance.

Greetings from Germany,

Claus

Please run the following install sequence.

For the E:
1: Install main base package
2: Install TACPACK package
3: Install ADV package

For the S/J:
1: Install main base package
2: Install ADV package

Hello Jonathan,
Thank you for your feedback.
I will try and keep you posted.
About the manual to learn how to fly the F-4, do you mean the huge one with the hundreds of pages?

Regards, and have a nice weekend,
Claus

Both that one and the ones at the bottom of the store pages.

Hello Jonathan,

I checked it with you recommended installation sequence for f4E...

Great, it works!!! For F4E everything is good now. I will check some more features within next days.

.
..and for F4S/J?

I am going to re-install according to your advisements very soon too.

Crossing my fingers that it will work in same way as for F4E.

I keep you posted.

Regards,

F4-phever

Oh, I miss to say thank you for your very appreciated support.

Regards, again,
F-4 Phever