Blackbird Sims / Milviz Forum Archive

Hello,

in the rear cockpit,at the Computer Control Panel, the coordinates indicated on the POSITION control knobs should be stored in the BASE memory of the navigation computer when the function switch is placed in the RESET position. Apparently it is not the case at the moment...
I guess it is the same issue that was described in this post
viewtopic.php?f=155&t=9329

Cheers
Vvince

I don't think that update has been released yet.

I thought that there had been an update in between, since the post I referred to is quite old, but I might be mistaken.
Looking forward to the next update with the corrected feature then.

Cheers
Vvince