Elevator Trim AXIS Direction assignment is reversed - MSFS SU5 v1.2.0
Posted: Mon Aug 23, 2021 3:19 am
Not the elevator trim itself, the Axis assignment.
In MSFS I set my throttle axis on my Logitech Extreme3D Pro to the Elevator Trim Axis -100% - +100% control to control the Elevator trim.
For the Milviz FG-1D (and Just Flight Cherokees and Big Radial Nieuport, but those are not your problem), I have to reverse the axis to get it to react in the correct direction (wheel forward nose down, wheel backward nose up). For the Default C152 and C172 (and Flying Iron Spitfire), I do not have to reverse the action of the axis.
Assuming the default aircraft have the correct action, can you please fix this issue? It's a pain in the butt to have to go into my control settings to change it every time I change my aircraft.
I'm using the v1.2.0 8/12 version from MV_FG-1D_v1.2.0_210812.exe install program I downloaded from the update notification email. (The manifest says 1.1.0, but, everywhere else it says 1.2.0 (install program, Apps and Features)). I uninstalled the previous version before I installed this version.
This was not an issue prior to SU5.
Thanks,
Tom
In MSFS I set my throttle axis on my Logitech Extreme3D Pro to the Elevator Trim Axis -100% - +100% control to control the Elevator trim.
For the Milviz FG-1D (and Just Flight Cherokees and Big Radial Nieuport, but those are not your problem), I have to reverse the axis to get it to react in the correct direction (wheel forward nose down, wheel backward nose up). For the Default C152 and C172 (and Flying Iron Spitfire), I do not have to reverse the action of the axis.
Assuming the default aircraft have the correct action, can you please fix this issue? It's a pain in the butt to have to go into my control settings to change it every time I change my aircraft.
I'm using the v1.2.0 8/12 version from MV_FG-1D_v1.2.0_210812.exe install program I downloaded from the update notification email. (The manifest says 1.1.0, but, everywhere else it says 1.2.0 (install program, Apps and Features)). I uninstalled the previous version before I installed this version.
This was not an issue prior to SU5.
Thanks,
Tom