Blackbird Sims / Milviz Forum Archive

Hi,

Using the MVAM for the Cessna 310, if I select the pilots/passengers I will only see a pilot and no passengers.




I've read the readme for the MVAM usage.

https://milviz.com/flight/tips.txt

I see that the config is done before loading the P3D sim (I have this installed on P3D V4.5 -
Sometimes when the Sim is loaded, I've been able to go to the MVAM and make changes and then relaod
the same aircraft and see that most of the changes have been made. In either case, I don't see and Pax when
that blocked is ticked.

Please insure you are running the MVAMS as an admin or it may not write to a settings file.

Edit: if you PM me an order number or proof of purchase I can put you in the 310R support forums.