Page 1 of 1
Unable to start
Posted: Wed Sep 29, 2021 3:59 pm
by alrocreation
Hello,
I bought the PC6 for FS2020 from your site yesterday. I had no problem installing it by following the instructions included in the pdf.
Unfortunately after selecting it and the departure airport, I could not start the PC6 even using Ctrl+E.
Also when selecting this aircraft, all my Saiteck modules disconnect and my joystick deactivates!!!. I have no problems with other aircraft such as the Corsair.
Question: why these bugs, would I have forgotten a manipulation?
Thank you for your answer,
Best Regards
Alain (AlroCreation)
Re: Unable to start
Posted: Wed Sep 29, 2021 4:47 pm
by mathieubellot
Idem pour moi!!!!
Re: Unable to start
Posted: Wed Sep 29, 2021 6:54 pm
by andy.kauffman
alrocreation wrote: ↑Wed Sep 29, 2021 3:59 pm
Unfortunately after selecting it and the departure airport, I could not start the PC6 even using Ctrl+E.
Hi! What happens if you start on the runway? The engines and electronics should be going then - if the aircraft shuts down after 5 or 10 seconds, then it is the DRM (WASM Helper Service) that has a problem and possibly is not starting.This is what I'm experiencing, and MILVIZ said that they should have a fix for us in a few days.
Does the Corsair use the same WASM Helper service?
Re: Unable to start
Posted: Wed Sep 29, 2021 6:58 pm
by Slayer
alrocreation wrote: ↑Wed Sep 29, 2021 3:59 pm
Hello,
I bought the PC6 for FS2020 from your site yesterday. I had no problem installing it by following the instructions included in the pdf.
Unfortunately after selecting it and the departure airport, I could not start the PC6 even using Ctrl+E.
Also when selecting this aircraft, all my Saiteck modules disconnect and my joystick deactivates!!!. I have no problems with other aircraft such as the Corsair.
Question: why these bugs, would I have forgotten a manipulation?
Thank you for your answer,
Best Regards
Alain (AlroCreation)
Ctrl-E does not work with this aircraft. If none of the controls are working then it is likely related to the WASM helper.
Re: Unable to start
Posted: Fri Oct 01, 2021 11:38 am
by jgisbertadell
To me the same thing happens to me.
What is WASM Helper Service?
Thanks
Re: Unable to start
Posted: Fri Oct 01, 2021 1:01 pm
by doodlebug
We are working on a build without the WASM helper.
We will post it first on the PC6 2020 support forum and then do a release. (Notifications by email).
I had hoped to have it ready already, but it is taking a little longer, as we are using this as an opportunity to do some minor fixes at the same time.