Is MV B350i HOLD at PPOS working in v1.2 ?
Posted: Thu Dec 03, 2020 4:26 pm
Has anyone been able to verify that the Hold at PPOS function is working in v1.2 for P3D4.5?
Hold at a specific fix works as expected. (Hold pattern is shown on MFD/PFD map, and airplane tracks pattern and flies entry/exits normally. Inbound crs, turn direction entries all work correctly.)
But when I try to use the INX\HOLD\NEW HOLD page and LSK the PPOS option, the airplane turns around, but no hold pattern appears on map display, and airplane keeps flying - never entering a hold.
Post on v0.0.35 from Sept 2019 reported that Hold at PPOS bug had been fixed (https://milviz.com/forum/viewtopic.php? ... POS#p92953). More recent post described hold entry procedures, but it is unclear what version was used, and whether procedure was verified for PPOS hold (https://milviz.com/forum/viewtopic.php? ... ld#p101378).
Can anyone else replicate ?
Chuck O
Hold at a specific fix works as expected. (Hold pattern is shown on MFD/PFD map, and airplane tracks pattern and flies entry/exits normally. Inbound crs, turn direction entries all work correctly.)
But when I try to use the INX\HOLD\NEW HOLD page and LSK the PPOS option, the airplane turns around, but no hold pattern appears on map display, and airplane keeps flying - never entering a hold.
Post on v0.0.35 from Sept 2019 reported that Hold at PPOS bug had been fixed (https://milviz.com/forum/viewtopic.php? ... POS#p92953). More recent post described hold entry procedures, but it is unclear what version was used, and whether procedure was verified for PPOS hold (https://milviz.com/forum/viewtopic.php? ... ld#p101378).
Can anyone else replicate ?
Chuck O