WX PATCH TO PREPAR 3D V3.4 BY MISTAKE
Posted: Mon May 13, 2019 10:10 pm
Ref: Order ID 0037170306 -- DHC-2 Beaver Standard Edition
Hello.
I mistakenly installed the May 5, 2019 MilViz Wx Radar patch for the DHC-2 Beaver --into Prepar 3D v3.4, instead of v3.5.
Ref: "This patch will fix CTDs when running the Wx in Prepar3D v4.5" (I have v3.4, not v3.5 -- so patching was my bad.)
As a result, since the patch, if I try to fly the Beaver, Prepar 3D v3.4 crashes within a few seconds of the Beaver being loaded.
What should I do to fix the problem? Should I remove the DHC Beaver from my computer then re-download and install it. And, if 'Yes,' which folders and files must be removed for a clean uninstall, please?
Thank you,
Peter H.
Hello.
I mistakenly installed the May 5, 2019 MilViz Wx Radar patch for the DHC-2 Beaver --into Prepar 3D v3.4, instead of v3.5.
Ref: "This patch will fix CTDs when running the Wx in Prepar3D v4.5" (I have v3.4, not v3.5 -- so patching was my bad.)
As a result, since the patch, if I try to fly the Beaver, Prepar 3D v3.4 crashes within a few seconds of the Beaver being loaded.
What should I do to fix the problem? Should I remove the DHC Beaver from my computer then re-download and install it. And, if 'Yes,' which folders and files must be removed for a clean uninstall, please?
Thank you,
Peter H.