B350i Select Button and speeds [Resolved - Chaseplane conflict]

[CS-TMT]

Small update:

- Uninstalled the aircraft and everything related (MVAMS), ran a scan with Advanced Uninstaller Pro to fully remove al leftovers.

- Restarted my computer.

- Installed the aircraft, MVAMS and all the extras that came in the pack.

- Restarted the computer again.

All these steps were performed with the antivirus deactivated.

Launched the sim (P3Dv4 HF3). Although I wasn't able to try it again because I had to go away from the PC, I only tried a few things and I am optimistic regarding the bouncing and jumping in flight, because I finally didn't have the "jumps" while sitting on the ground (I have been having it since my first installation, but only small jumps and only on the ground. In the air I only had them in the previous installation). However, regarding the ESIS MMB issue, I could verify that the issue remains, which however I am perfectly capable of living with it.
I will try to fly it later today and will write back when I do it to keep updated regarding flying issues.

[CS-TMT]

Doing a flight right now as I write and all appears to be OK now. The plane bounces a liiitle bit while on the ground with chocks, but as soon as I take them out and apply parking brakes, it stands still. And the issues regarding inflight bouncing and vertical AP incapacitation are gone. The only issue for me is the ESIS MMB, with which I can perfectly live.

[CS-TMT]

Just did my first successful flight with this amazing bird! Simply amazing! Apart from my remaining issue with the ESIS, which for me is not very important.

[luis.sanchi.m]

Maybe try moving your view point. If everything else is working I can't understand why you can't click the buttons. Pressing B will sync the baros.

Yes, I am doing that, but it is not the correct way jeje. For me its impossible, that doesnt works

[luis.sanchi.m]

Hi! Im happy because I have found the problem. Its a conflict with Chaseplane. I have deselect this button function in chaseplane and now "select Button" in the KingAir works.

Thnaks a lot!

[Slayer]

Hi! Im happy because I have found the problem. Its a conflict with Chaseplane. I have deselect this button function in chaseplane and now "select Button" in the KingAir works.

Thnaks a lot!

Glad you are sorted as well.