Page 1 of 1
adv meny
Posted: Wed Jul 25, 2018 1:59 pm
by wen
Hi! Everytime when I start up F-4E adv I have to go to adv meny and configure the aircraft. My adv settings are not saved as before the latest update. After the update the aircraft will not start with engine running. I load F-4E and then I have to click at "nucl store consent" to start the engine.
Re: adv meny
Posted: Wed Jul 25, 2018 2:38 pm
by Krazycolin
Run the mvams and the sim as administrator
Re: adv meny
Posted: Wed Jul 25, 2018 2:39 pm
by Krazycolin
Which, btw, is in the manual. Maybe you should read it.
Re: adv meny
Posted: Wed Jul 25, 2018 3:43 pm
by JonathanBleeker
As KC said, running as admin is required. It sounds like your AMS and your sim are not being allowed to read and write to the config files.
Re: adv meny
Posted: Wed Jul 25, 2018 10:36 pm
by wen
I always read the manual. That's the way I always learn about a new software. The MVAMS runs already as Admin. Before the latest update everything works fine.
Re: adv meny
Posted: Thu Jul 26, 2018 7:04 am
by JonathanBleeker
Is your default flight one which starts engines running? Do the AMS settings at least persist?
Also while the AMS is set to run as admin, what about your sim? Did you update that recently?