Page 1 of 1
Two Gaps.
Posted: Thu Nov 09, 2017 8:02 pm
by wen
Hey! How do you fold the two gaps underneath the airplane? They are located near the speed brake units. What do these two gaps have for function?
Re: Two Gaps.
Posted: Thu Nov 09, 2017 8:07 pm
by Krazycolin
When you’re on the ground those two panels are open all the time. They are for cooling the ringtones. They cannot be closed. Once gear goes up, so do the panels.
Re: Two Gaps.
Posted: Thu Nov 09, 2017 8:44 pm
by wen
Thank´s for the information! I have another concern. The engines stop without warning and the aircraft goes to cold and dark status. The problem occurs approximately 4 minutes after starting.
Re: Two Gaps.
Posted: Thu Nov 09, 2017 8:53 pm
by Krazycolin
both engines are running? You turned on the gens? Followed the manual/video exactly? Moved throttles forward? etc?
Re: Two Gaps.
Posted: Fri Nov 10, 2017 9:30 am
by wen
Yes, both engine starts by the book and the generators are on. I have start up the F 4E about 25 times before, without complications but yesterday they turn off for no reason. I have no created failure programmed.
Re: Two Gaps.
Posted: Fri Nov 10, 2017 9:38 am
by Krazycolin
So... do they turn off every time now?
Because if they did it only one time, it's likely you missed something....
Re: Two Gaps.
Posted: Fri Nov 10, 2017 11:58 am
by JonathanBleeker
Do you have any special hardware assignments? Anything you set in the AMS?
Re: Two Gaps.
Posted: Fri Nov 10, 2017 4:37 pm
by Alvaro
wen wrote:I have no created failure programmed.
If you have the realism bar at any position other than full left and you have realistic systems, engines, etc...selected, then it could be a random failure, not a programmed one.
Re: Two Gaps.
Posted: Wed Nov 15, 2017 12:56 pm
by wen
Thank`s! Maybe a time laps failure.