Blackbird Sims / Milviz Forum Archive

Hi! I have programmed two buttons on my throttle to control engine ignition but the button for this function in VC does not move. I have F 4E advance.

We are somewhat at the limit of animations in this cockpit and as such had to devote them to more vital animations. You would want to be looking at the engine instruments while pushing them anyway.

The problem is not that they are not moving. The problem is that they lack function. Before my re installation there was no issue whit that function, only the NWS and light in VC. Now the NWS and VC light working but the L-R start button does not.

This is in addition to the start switch? In otherwords, the engine spools up but fails to ignite?

The right engine will not spole up because the startar switch does not move to the right. Left engine start without problem because the start switch can move to the left. I have edit button in MVAMS. Ignition 1 and 2 are programmed exakt the same but only one of them works. If I mouse click on the switch L and R works fine but it feels pervert to mouse click in a advance simulator:-)
I can start the L-R ticking noice, and engine master 1-2 with my programmed button but only the left ignition button(=engine L start button).

Bit of confusion here. Please send a screenshot of the exact commands in the AMS that aren't working

I add two pic. Engine two ignition do not work. Engine one ignition works fine.

How about Engine 2 Start? does it work?

Yes, engine two start works fine (starting a ticking noice) and engine two master on works fine to.