Blackbird Sims / Milviz Forum Archive

Left aileron/spoiler does not work
Utility is good
PC is good
Stab. trim 2.5 nose dn
Stab aug. Sw,s On
Com. Antenna upper
Antiskid on
I cant T.O normally
About airspeed 140_160 nose strut settle on the runway

I studied full manual _1 and know T.O procedures
Im cofused. What is the problem?

Verify crash detection realism slider is set to minimum in your realism settings, also please post a screenshot of your F-4 ADV failures menu (accessible via Addons Menu). Check that the nose gear isn't set to failed in P3D failures menu.

Realism set to fully left

I searched every where in p3d menu and MVAMS , Didnt find "F4 adv failure"

My add_on menu is empty
But in the failure menu, which i will send you screenshot, no eny failure is set...

What about aileron/spoiler?
What about no add-on menu?
What about nose strut failur?

Cause of couldnt take off by f4e, i selected f22 for take off, after take off switched vehicle to f4e again... at the moment it became out of control. The interesting point is that f4 remained at sky and never impact to the ground...even its strange that i saw raise in altitude during out of control....

Any way.. i disappointed of using my f4. I couldnt use it so far...

Looks like the ADV files aren't properly installed. Run the ADV installer again and make sure to run it as admin (right click->Run as admin).

Several time i unistall completely and install again proceduraly all of 3 file. Basic tackpack adv


Run as admim

It doesnt improve...

After uninstall all of them, then installing just only base, i have no problem. But no tackpack and no adv

How can i use them

Verify you have a F4EADVConfigurationMenu.dll in your F-4 panel folder, along with a F4_mod.dll in the F4ADV folder in your panel folder

Yes they are exist.
But the problems are still there.

JonathanBleeker wrote: ↑

Mon Oct 28, 2019 6:25 pm

Verify you have a F4EADVConfigurationMenu.dll in your F-4 panel folder, along with a F4_mod.dll in the F4ADV folder in your panel folder

Yes they are exist.
But the problems are still there.

Please right click on those dlls and select properties and check if there is an unblock button/checkbox.

JonathanBleeker wrote: ↑

Thu Oct 31, 2019 4:39 pm

Please right click on those dlls and select properties and check if there is an unblock button/checkbox.

Hello again
I followed your instruction
Checkboxes are empty

I cant take off
Only right aileron works
Another aileron spoilers did not work.



Befor installing adv , every thing was normall
How can i resove it?

I think I need to do a teamviewer session with you. What times are you usually available according to UTC time?

JonathanBleeker wrote: ↑

Sun Nov 03, 2019 7:23 am

I think I need to do a teamviewer session with you. What times are you usually available according to UTC time?

Hi sir
15:00 to 20:00 utc
If possible to you...
Tnq

Works for me. You available today?

JonathanBleeker wrote: ↑

Sun Nov 03, 2019 1:21 pm

Works for me. You available today?

Yes sir. Im ready. Determine a time
Check your massage
I will send you social network ID,
Email and phone number to coordination..