Blackbird Sims / Milviz Forum Archive

Hi: Just to make sure I am understanding the P3D Ver. 4.4.updating correctly.

1. I have the F-4 J/S and the adv module. With this I can use tack pack, and I do not need to purchase an update for P3D Ver. 4.4 and later.
2. I have the F-4E and the adv module. With this I do not need to purchase an update, but I do need to purchase the tack pack module to use tac pack.

Do I have this correct. I don't mind purchasing updates if I have to cause you guys have given me a lot of joy over the years. Just checking.

Mike Gutierrez, North Hollywood, California.

If you have the ADV, you are version proof .

However, TP will be part of our update offer (coming soon) - so you would be better off holding off for the update if you want to add TP as you will save $$$.

Also, once we have everyone updated we will withdraw the addon modules, leaving only one complete product for the F-4E and one for the F4-J/S.

Thanks for your response and your great products and service. Mike Gutierrez

Hi, I also read your December 11 2018 post at your website about Prepar3d v4.4 products update and I'm a little bit confused.

I started by buying F-4E/J/S bundle, later bought F-4E TacPack module, later on F-4E Advanced module, then F-4J/S Advanced module.

What else should I buy and/or install for me to have everything listed above working in Prepar 3D v4.4 and Tacpack?

I didn´t install anything in P3D v4.4 yet.

Thanks in advance!

It looks like you have all you need. (It's the ADV modules that are what's required.)

Thanks, Oisin!

Hi,

My ADV F-4 does a CTD in P3D v 4.5. Any updates or suggestions?

Thanks in advance

Can you give us the sequence of events?
Was it running correctly in the previous version of Prepar3D?

Osh, thanks for reaching out. It turned out to be "pilot error". I didn't install the base and advanced versions in the proper order. Thanks for the Phantom Phix!