Confirming P3d Ver. 4.4 Updates

[mongo501]

Hi: Just to make sure I am understanding the P3D Ver. 4.4.updating correctly.

1. I have the F-4 J/S and the adv module. With this I can use tack pack, and I do not need to purchase an update for P3D Ver. 4.4 and later.
2. I have the F-4E and the adv module. With this I do not need to purchase an update, but I do need to purchase the tack pack module to use tac pack.

Do I have this correct. I don't mind purchasing updates if I have to cause you guys have given me a lot of joy over the years. Just checking.

Mike Gutierrez, North Hollywood, California.

[doodlebug]

If you have the ADV, you are version proof .

However, TP will be part of our update offer (coming soon) - so you would be better off holding off for the update if you want to add TP as you will save $$$.

Also, once we have everyone updated we will withdraw the addon modules, leaving only one complete product for the F-4E and one for the F4-J/S.

[mongo501]

Thanks for your response and your great products and service. Mike Gutierrez

[espiree]

Hi, I also read your December 11 2018 post at your website about Prepar3d v4.4 products update and I'm a little bit confused.

I started by buying F-4E/J/S bundle, later bought F-4E TacPack module, later on F-4E Advanced module, then F-4J/S Advanced module.

What else should I buy and/or install for me to have everything listed above working in Prepar 3D v4.4 and Tacpack?

I didn´t install anything in P3D v4.4 yet.

Thanks in advance!

[doodlebug]

It looks like you have all you need. (It's the ADV modules that are what's required.)

[espiree]

Thanks, Oisin!

[george]

Hi,

My ADV F-4 does a CTD in P3D v 4.5. Any updates or suggestions?

Thanks in advance

[doodlebug]

Can you give us the sequence of events?
Was it running correctly in the previous version of Prepar3D?

[george]

Osh, thanks for reaching out. It turned out to be "pilot error". I didn't install the base and advanced versions in the proper order. Thanks for the Phantom Phix!