oxygen pressure and IFF control test
-
HenryW
- Posts: 39
- Joined: Wed Apr 26, 2017 9:34 pm
oxygen pressure and IFF control test
Hi,
I discovered two minor issues using the wonderful and detailed F-4E (Advanced with TacPack, latest build) on my FSX:SE system.
On the oxygen control panel, the oxygen pressure gauge remains at zero pressure when switching on the oxygen. If I remember correctly, this did work on a previous version, as also shown at some older videos on Youtube.
On the IFF control panel, when putting the mode switches (e.g. for mode 3A) to ON (middle switch position), the TEST light will illuminate. When putting the switch in the TEST position (upper switch position) the light turns off. This should be the opposite. In the F-4J/S this is modelled in the correct way.
Again, both are minor issues, which hardly distract from realism, but I'd like to point them out nevertheless.
Best regards,
Henry
I discovered two minor issues using the wonderful and detailed F-4E (Advanced with TacPack, latest build) on my FSX:SE system.
On the oxygen control panel, the oxygen pressure gauge remains at zero pressure when switching on the oxygen. If I remember correctly, this did work on a previous version, as also shown at some older videos on Youtube.
On the IFF control panel, when putting the mode switches (e.g. for mode 3A) to ON (middle switch position), the TEST light will illuminate. When putting the switch in the TEST position (upper switch position) the light turns off. This should be the opposite. In the F-4J/S this is modelled in the correct way.
Again, both are minor issues, which hardly distract from realism, but I'd like to point them out nevertheless.
Best regards,
Henry