Update v4.4 issue

[wen]

Hi! When I use my F-4E software licens in P3Dv4.4 the aircraft will not auto start. I use MVAMS "Ready To Fly" mode. When I then click the button in the aircraft for autostart sequence it result in a fire at engine 2.

[Alvaro]

Tested in v4.4 no issues found in the Ready to Fly condition.

An engine fire in the startup is caused by a prolonged and/or early advanced throttle (idle = fuel valve open ) when the mixture is ignited.

What's "autostart sequence..." ?

Remember the correct installation sequence :

1) F4E baseline
2) F4E tacpack
3) F4E ADV

[Alvaro]

Also confirmed, no issues in P3D v4.4 with Cold&Dark starts in both modes: cartridge and GPU aided.

[wen]

Thank´s for info! It must be my system who causes the issue. Auto start sequences = push the "Nuclear release" button in V.C.

[wen]

Maybe it is necessary to uninstall - install the F-4E after the P3Dv4.4 update.