The flight model of my installation seems to be not working.

[navatpi]

Hello,

from what I could fly so far I really like the plane, however, there seems to be a problem with my flight model.

When I bank the plane to the left or right, it just keeps flying straight and after a few seconds it starts turning. Really quickly, as it would compensate for the time it has not turned.

I am running a clean, newly installed version of FSX: Steam Edition on Windows 10. I also have the problem with the Flight1 GTN 750. I can't click it, the 650 next to it works perfectly and the pop-up too. I read your post about those gauges and I completely understand you, it would be nice to have a solution though.

Thanks and best regards, Noah

[Krazycolin]

Sounds like you have a calibration issue.

[wells]

When I bank the plane to the left or right, it just keeps flying straight and after a few seconds it starts turning. Really quickly, as it would compensate for the time it has not turned.

Check the control sensitivity for the roll axis is all the way to the right.

[navatpi]

Check the control sensitivity for the roll axis is all the way to the right.

Thank you! I tried it out and it seems somehow fixed. I could fly for half an hour, then the issue suddenly came again, but only for a short time. I don't know why, but it seemed to vanish when I increased the altitude on the autopilot, though I have not used AP. Maybe it was just a coincidence. I will get the plane out flying and will tell you if I can find out more.

[Krazycolin]

It may be the your stick is dirty.

[N4GIX]

I also have the problem with the Flight1 GTN 750. I can't click it, the 650 next to it works perfectly and the pop-up too. I read your post about those gauges and I completely understand you, it would be nice to have a solution though.

Well Noah, your wish has been fulfilled. I found and fixed the GTN750 non-clickable issue this afternoon. It will be in the next installer I build, hopefully by tomorrow afternoon.

[navatpi]

It may be the your stick is dirty.

Solved it, sorry, my mistake. I am using two Joysticks, one for controls and one for throttle. I did not recognize there is a drop-down menu to select joysticks. Now it works like a charm. Thanks a lot!

Well Noah, your wish has been fulfilled.

That sounds really good, thank you so much! Can't wait to finally use this beauty as my workhorse on IVAO soon