Page 1 of 1
Fuel gauge on v3.180412 SP3.4 doesn't work?
Posted: Mon Apr 30, 2018 2:55 pm
by Buffy
I've tried flipping the switch both ways, but they still read as full after 1.5 hours of flying. Also that gauge switch goes up fine with the mouse wheel, but not back down, i have to click a couple times to get it to go down.
Re: Fuel gauge on v3.180412 SP3.4 doesn't work?
Posted: Mon Apr 30, 2018 3:15 pm
by N4GIX
I'll check the fuel gauge. Dont' use the mouse wheel on the switch. It is spring loaded and should only be activated with left/right mouse buttons.
Re: Fuel gauge on v3.180412 SP3.4 doesn't work?
Posted: Mon Apr 30, 2018 3:56 pm
by Buffy
ok thanks
Re: Fuel gauge on v3.180412 SP3.4 doesn't work?
Posted: Wed May 09, 2018 11:50 pm
by Buffy
OK I figured out what I did to make them not work. I had used the mouse wheel to flip the switch, and that put the switch in the up position but without the spring putting it back in the middle. Then the needles also would not change from where they were. Using the mouse buttons fixes it though.
Re: Fuel gauge on v3.180412 SP3.4 doesn't work?
Posted: Thu May 10, 2018 12:32 am
by N4GIX
Great! Thanks for the follow up report.
