Page 1 of 1

raised air stairs visible on cabin floor

Posted: Mon Apr 09, 2018 10:47 pm
by ThomasAH
With v3.180409 SP3.1 (and probably older versions, too) I noticed a small red spot (it looked brighter in the sim than on the screenshot) on the cabin floor from outside the aircraft.
This is visible using the interior model, too, (see lower part of the image) and turns out to be the raised air stairs below the seat in the rear right:
airstairs-cabin-floor.jpg
airstairs-cabin-floor.jpg (89.86 KiB) Viewed 1691 times

Re: raised air stairs visible on cabin floor

Posted: Mon Apr 09, 2018 10:51 pm
by ThomasAH
P.S.: The lower screenshot shows the strobe light visible from inside the cabin, which is not only visible at the pictured floor level, but also from some other positions. Is this something that can be fixed (I'm using FSX), and if yes, should I create a separate thread?

Re: raised air stairs visible on cabin floor

Posted: Mon Apr 09, 2018 11:12 pm
by Krazycolin
If you’re at floor level, who is flying the plane?

Re: raised air stairs visible on cabin floor

Posted: Tue Apr 10, 2018 5:41 am
by raymie1028
Maybe it is "Otto" Pilot :roll:

Re: raised air stairs visible on cabin floor

Posted: Tue Apr 10, 2018 7:53 am
by ThomasAH
Krazycolin wrote:
Mon Apr 09, 2018 11:12 pm
If you’re at floor level, who is flying the plane?
That's just the camera, maybe I used a selfie stick to identify where the grating noise comes from that started after raising the gear? :lol:
But it is visible from more reasonable positions, too, just not that clearly.

Re: raised air stairs visible on cabin floor

Posted: Wed Apr 11, 2018 6:41 pm
by N4GIX
Odd that no one ever noticed the steps under the rear seat before. Then again, probably no one ever stood on their head in the cabin to peek under the seats either. As for the rear light showing through in your screenshot, that has to do with the sim's camera clipping plane and there's really nothing I can do about that. You could likely fix that yourself by editing the default cameras.cfg file and adding the parameter:
ClipMode=Minimum to the VC camera.

In any case I created a recessed 'housing' in which the steps are now stored:
Image

Re: raised air stairs visible on cabin floor

Posted: Wed Apr 11, 2018 7:01 pm
by ThomasAH
N4GIX wrote:
Wed Apr 11, 2018 6:41 pm
You could likely fix that yourself by editing the default cameras.cfg file and adding the parameter:
ClipMode=Minimum to the VC camera.
Thank you, I'll try that, and I'm looking forward to see the housing for the stairs 🙃