Page 1 of 1
one of three still prop blades twisted
Posted: Mon Apr 09, 2018 4:24 pm
by ThomasAH
v3.180408 SP3 introduced this very nice feature: Adjusted still prop blades to assume a 20º angle
This looks good for two-thirds of the blades, but one on each side is twisted the wrong way (as already reported by N918JC in the SP3 announcement thread):

- 2080408-SP3-props.jpg (201.63 KiB) Viewed 1369 times
FSX boxed (in case that matters)
Re: one of three still prop blades twisted
Posted: Mon Apr 09, 2018 4:51 pm
by N4GIX
But... it helps counteract torque!
Seriously, I caught and fixed this when I cloned/replaced the oddball blade on each side.
What is truly odd though is that until yesterday, no one had noticed the rogue blades on each side. Just goes to show how difficult it sometimes is to find and fix so many things on a complex project.

Re: one of three still prop blades twisted
Posted: Mon Apr 09, 2018 5:19 pm
by N918JC
N4GIX wrote: ↑Mon Apr 09, 2018 4:51 pm
Just goes to show how difficult it sometimes is to find and fix so many things on a complex project.
Well... I'd say it's might near impossible. But once again you have demonstrated that even the impossible can become possible with faith and devotion.
Look forward to your fix and thanks once again, Bill.
Jesse Cochran
Re: one of three still prop blades twisted
Posted: Mon Apr 09, 2018 9:57 pm
by ThomasAH
Looks perfect now in SP3.1, thank you again!