Blackbird Sims / Milviz Forum Archive

Hi,

So Im a bit confused as to what happens when I have P3D 4.3, the beaver AND the REX / Milviz standalone WX Radar package.

Right now the Wx radar in the VC does not work. It shows installed in my wx radar config program but only the 2D pop up works.

How does the Beaver installer know I already have the Wx radar installed?
How does it work when there is a new version of wx radar for P3D v4.3 (released in July)but the Beaver installer hasnt changed since December? I havent had any updates via MVAMS either.

Thanks for any help / further info.

Anyone here from support able to answer this?

Apologies for overlooking it.

We have been having some problems in P3D v4.3 where the WX has been causing difficult to track CTDs. We are almost finished with solving them though and will be putting out some updates soon.

JonathanBleeker wrote: ↑

Fri Aug 31, 2018 12:51 pm

Apologies for overlooking it.

We have been having some problems in P3D v4.3 where the WX has been causing difficult to track CTDs. We are almost finished with solving them though and will be putting out some updates soon.

Hi, thanks for the reply.

When its fixed, what is the procedure for those that already have the Wx standalone package?

You will get both (the standalone from REX and our locked version as well).

Hallo, here´s the same. The Beaver with the wx-radar = P3D v4.3 crashed .
mfg Harald

Thanks for this wx-radar-update. Make a short flight for 20 minutes and all seems to work fine.
mfg Harald