Page 1 of 1
Boost Coil Switch
Posted: Sat Jun 02, 2018 7:15 am
by helbel
Hallo,
I have the Beaver with P3D 4.2. I can not move the boost coil switch with mouse up/down. The switch don´t work. A reinstall shows the same. Can you help me?
Greetings Harald.
Re: Boost Coil Switch
Posted: Sun Jun 03, 2018 12:32 pm
by sunjunkiesi
From the manual, page 22;
When the switch is held to the BOOST COIL position,
high tension electrical current is supplied to the engine
spark plugs to initiate starting. (The boost coil switch,
not always found in DHC-2’s with upgraded electrical systems,
has been made INOP.)
Re: Boost Coil Switch
Posted: Mon Jun 04, 2018 8:33 am
by helbel
Thank you, I understand now, than it is only for starting held shortly.
Gr Harald.
Re: Boost Coil Switch
Posted: Mon Jun 04, 2018 12:21 pm
by Krazycolin
Inop = doesn’t do anything