Page 1 of 1
DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavior
Posted: Wed Oct 25, 2017 3:11 am
by Eagle Spirit
I just installed a new high end system and installed your "Beaver", which I previously have enjoyed flying, into P3D v4.1.However, in early flying, the Beaver speed indicator fluctuates wildly, 0 to over speed (gauge only). I flew the tundra version today, and it seemed better in flight.
Whats up?
Eagle
Re: DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavio
Posted: Wed Oct 25, 2017 3:15 am
by Krazycolin
Hi... we've not tested anything in really in 4.1 but that said, we're aware that LM has made some changes... we will investigate. But, please, don't expect an answer right away.
Thanks.
Re: DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavio
Posted: Wed Oct 25, 2017 3:22 am
by Eagle Spirit
TYVM!
Eagle
Re: DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavio
Posted: Wed Oct 25, 2017 3:24 am
by Krazycolin
Also, please post this type of thing in the support forums. That's what they're there for...
Thanks
Re: DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavio
Posted: Wed Oct 25, 2017 11:07 am
by Taguilo
Eagle Spirit wrote:I just installed a new high end system and installed your "Beaver", which I previously have enjoyed flying, into P3D v4.1.However, in early flying, the Beaver speed indicator fluctuates wildly, 0 to over speed (gauge only). I flew the tundra version today, and it seemed better in flight.
Whats up?
Eagle
Please remove the pitot covers before rolling on the ground (as that can't be done with the aircraft in motion).
Tom
Re: DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavio
Posted: Wed Oct 25, 2017 4:08 pm
by sunjunkiesi
I'd also suspect icing. Were you operating in low temperatures and damp conditions?