Page 1 of 1
Can't rotate ignition to off or fuel handle after update
Posted: Thu Oct 19, 2017 2:48 pm
by VetteDrvr
Hi, after the most recent update I can shut off the engine with the fuel mixture lever. And shut off the battery switches but I can't rotate the ignition switch to the Off position nor can I any longer rotate the red fuel handle to off.
Has anyone else seen this? What could I be doing wrong?
Thanks.
Re: Can't rotate ignition to off or fuel handle after update
Posted: Thu Oct 19, 2017 6:05 pm
by Taguilo
Hi
For security reasons, fuel and ignition switches only go to OFF position by pressing mouse's middle button (scroll wheel).
Tom
Re: Can't rotate ignition to off or fuel handle after update
Posted: Thu Oct 19, 2017 9:50 pm
by VetteDrvr
Thanks, I'll try that, I knew I read this somewhere before!
Re: Can't rotate ignition to off or fuel handle after update
Posted: Sun Oct 22, 2017 5:02 pm
by Nirgal76
As my mouse doesn't have middle button on wheel but has 2 buttons on the left side, i use this software to map middle button to one of those 2 side buttons:
(it can be helpfull to others with same problem as me)
"x-mouse button control"
Re: Can't rotate ignition to off or fuel handle after update
Posted: Mon Oct 23, 2017 1:10 am
by N4GIX
Odd mouse. Most wheels are able to be 'pressed down' and act as a button. Happy to hear you found an extra button though!

Re: Can't rotate ignition to off or fuel handle after update
Posted: Mon Oct 23, 2017 7:04 pm
by Nirgal76
N4GIX wrote:Odd mouse. Most wheels are able to be 'pressed down' and act as a button. Happy to hear you found an extra button though!

a old Dell mouse found at my job. One of the worst mouse on earth

the wheel can be pressed but not any software i used can map this button. Perhaps it is broken.
Re: Can't rotate ignition to off or fuel handle after update
Posted: Sat Oct 28, 2017 12:45 pm
by caleb
Taguilo wrote:Hi
For security reasons, fuel and ignition switches only go to OFF position by pressing mouse's middle button (scroll wheel).
Tom
Thanks very much Tom.
I was having the same question and this answered it.
Thanks